🔍 Duct Leakage Guide — Martin County

Air Duct Leaks in Hobe Sound, FL
Salt Air, Big Estates, Quiet Losses

Hobe Sound sits right beside Jupiter Island, home to some of the most affluent beachside estates in Florida — and even the best-kept estate loses cooling through its ductwork when salt air, attic heat, and age open up the joints. From Poinciana Gardens to Heritage Ridge, here is how air duct leaks start in Hobe Sound homes, what they cost you, and how they get sealed to code.

An attic plenum and duct joints coated in white UL 181M code-standards duct sealant

Sealed Joints, Sealed System

An attic plenum and duct joints coated in white UL 181M code-standards duct sealant — Air Duct Specialists LLC

Air duct leaks in Hobe Sound, FL do not announce themselves. There is no puddle and no alarm — just a guest wing that stays warm, a bill that creeps up month after month, and a house that feels a little clammy by evening. The U.S. Department of Energy estimates the typical home loses 20 to 30% of its conditioned air through duct leaks, gaps, and deteriorated connections. In a large beachside estate, that lost air is dumped into a 130- to 150-degree attic before it ever reaches a room. You paid to cool it. The attic got it.

Hobe Sound homeowners expect work done right and done discreetly, and duct leakage is exactly the kind of hidden problem that rewards that standard. Many properties here are seasonal estates that sit closed for months at a time. A small leak in April can mean a whole summer of humid attic air being pulled into a closed house, with no one inside to notice the musty smell in the closets. Finding and sealing leaks before the house sits prevents that.

Supply Leaks Waste Air. Return Leaks Pull Humidity In.

A supply-side leak is straightforward: cooled air escapes through a gap at a joint, a corroded seam, or a torn section of flex before it reaches the vent, and the room at the end of that run gets whatever is left. The system runs longer to compensate, and the electric bill absorbs the difference.

A return-side leak is the more damaging one in Hobe Sound. Returns work under suction, so a gap pulls air in instead of pushing it out — hot attic air, dust, insulation fibers, and all the moisture that air carries. Indoor humidity climbs, rooms feel sticky even at the right temperature, and mold gets a steady supply of what it needs on the coil and around the registers. In a seasonal home that sits closed, that process runs unchecked for months. When a Hobe Sound home has both high bills and a humidity problem, leaky returns are where we start.

The Signs Your Ducts Are Leaking

Leaks are consistent, and that consistency is the tell. Watch for:

One caution: a closed damper, furniture over a vent, or a failing blower can imitate a leak for a day. A leak is there every day, on the same branch, until someone seals it.

What Causes Air Duct Leaks in Hobe Sound, FL?

Salt-air corrosion leads the list for beachside properties. Salt works on the screws, collars, and folded metal seams that hold a duct system together, and homes near Jupiter Island and along the Intracoastal get no break from it. Joints loosen as the metal around the fasteners weakens, and pinholes open in seams that looked solid a few years ago.

Attic heat and aging ducts lead the list everywhere else. Older beachside homes in Poinciana Gardens and Heritage Ridge often run ductwork that has spent decades in an attic hitting 130 to 150 degrees in summer. The flex liner gets brittle, the outer jacket splits, and the tape at each connection dries out and lets go. Sections get stepped on, kinked, and crushed during every other trade's visit, and a crushed section can cut airflow to that branch by half.

Long runs in large estates multiply everything. A big Hobe Sound estate does not have a short, simple duct system — it has long runs, many branches, guest wings, and often more than one system. Every joint, elbow, and takeoff is a potential leak point. Add joints that were taped instead of sealed when the house was built and connections never fully reconnected after a past repair, and most older systems here leak at several points at once. A single patch rarely ends the story.

Checking for Leaks Yourself — and Getting an Exact Number

You can find the worst leaks with no tools. Set the fan to "on," go into the attic early in the morning before it heats up, and bring a flashlight. Move slowly along each run and pass your hand over every seam, elbow, and connection at the plenum and the air handler. Escaping supply air feels like a cool jet; a return leak feels like it is pulling at your palm. A strip of tissue held near a joint will flutter or get drawn in at a leak. While you are there, look for peeling tape, dust streaks fanning out from a joint, disconnected sections, and rust blooming along metal seams.

For a measured answer, a professional duct leakage test seals the registers and returns, pressurizes the system with a calibrated fan, and reports the total leakage in CFM. It catches the leaks no hand can reach — inside walls, chases, and ceilings — and gives you a before-and-after number, so a sealing job can be verified instead of taken on faith.

A flex duct and junction box coated in white UL 181M code-standards duct sealant

Every Junction Counts

A flex duct and junction box coated in white UL 181M code-standards duct sealant — Air Duct Specialists LLC

The Fix: Sealed to UL 181M Code Standards

The repair that holds is UL 181M code-standards duct sealant — a thick, brush-on sealant that fills irregular gaps, stays flexible as it cures, and bonds to both metal and flex. Gaps wider than a quarter inch get fiberglass mesh pressed into the wet sealant and a second coat over the top. Smooth metal seams take UL 181 foil tape. What does not hold is the cloth duct tape hanging off joints in half the older attics we open: its adhesive gives up under heat and pressure cycles, often within a season, which is how a "fixed" leak comes back.

The work starts where leaks concentrate — the air handler connections and the plenum — then follows every takeoff, elbow, and joint outward, returns included. On beachside homes, corroded fittings that can no longer hold a seal get replaced rather than coated over; sealant over rust is a short-lived repair and we will tell you so on site. Where insulation has failed around a sealed joint, it gets restored, because a sealed duct in a bare jacket still loses cooling to attic heat.

While we are in the attic, we also check the coil and blower — a system that ran for years with leaky returns has been pulling attic dust across its coil the whole time, and sealing without cleaning leaves half the problem in place.

What It Costs — and When Sealing Is the Wrong Answer

Sealing is priced on the size of the system and how much of it can be reached, and the honest way to get a number is a free on-site estimate — what we quote is what you pay, with no hidden fees. When homeowners price air duct leaks in Hobe Sound, FL, sealing sound ductwork is almost always the lowest-cost fix with the fastest payback, because the savings start with the next electric bill.

But sealing has a limit, and we will name it when we see it. Sealing to UL 181M code standards fixes joints and seams; it does not fix flex duct that is torn, crushed, or so old its insulation has lost its value, and it does not fix metal duct that salt air has eaten through. When the ducts themselves are at the end, the honest conversation turns to a full duct replacement for an average smaller residential home, priced on a free on-site estimate and varying on home sizing, layout, and materials required. Most average homes take at most 1–2 days for a full replacement. If your ducts can be sealed and saved, that is what we will recommend — no upselling, ever.

Serving Hobe Sound & Martin County — Free Duct Check

Air Duct Specialists LLC serves Hobe Sound and Martin County. Licensed CAC1825166. Fully insured. 350 five-star reviews. Service 7 days a week, 7am–11pm. Free estimates — what we quote is what you pay.

📞 (561) 331-6777
📋 Request a Free Estimate Online

Frequently Asked Questions

Why are beachside homes near Jupiter Island more prone to duct leaks?

Beachside properties live in salt air every day, and salt corrodes the metal seams, screws, and collars that hold duct joints together. Joints open as the metal around the fasteners weakens. Large estates add a second problem — very long duct runs with many more joints, elbows, and takeoffs, so there are simply more places for cooled air to escape.

What are the signs my air ducts are leaking?

One room that never cools like the rest, weak airflow at the far vents, electric bills rising without a change in habits, dust building up around registers, a faint hiss near a duct joint, and a system that runs longer than it used to. A leak follows a pattern: the same branch underperforms at every thermostat setting, in every season.

How are duct leaks found in a Hobe Sound home?

Start with what you can reach: run the fan, move along the attic ducts, and feel each seam and joint for escaping air, or hold a tissue strip near the joint and watch for flutter. Look for peeling tape, dust streaks, rusted metal seams, and disconnected sections. For an exact number, a professional duct leakage test pressurizes the system and measures the loss in CFM, including hidden leaks.

How are leaking air ducts sealed?

Accessible joints are sealed with UL 181M code-standards duct sealant, a brush-on sealant that stays flexible and fills irregular gaps, reinforced with fiberglass mesh on larger openings. Smooth metal seams take UL 181 foil tape. Ordinary cloth duct tape is not the fix — attic heat and pressure cycles loosen its adhesive until it peels.

Can leaky ducts cause humidity and mold in a seasonal Hobe Sound home?

Yes. A return-side leak pulls hot, moisture-heavy attic air straight into the airstream. In a seasonal estate that sits closed for months, that extra moisture raises indoor humidity, makes rooms feel clammy, and gives mold what it needs on the coil, in the duct lining, and around ceiling registers — often while no one is there to notice. Sealing the returns is usually the first fix.

Do you serve Hobe Sound, and are you licensed and insured?

Yes — Air Duct Specialists LLC serves Hobe Sound and Martin County, with service 7 days a week, 7am–11pm, and free estimates. We are a licensed Florida air conditioning contractor, license CAC1825166, fully insured, with 350 five-star Google reviews. Our certified techs — never subcontractors — do the work, and the license can be verified through the Florida DBPR.

Related Articles

AC Coil Cleaning in Hobe Sound, FL

How a dirty coil chokes airflow and leads to a freeze-up

AC Not Cooling in Hobe Sound, FL

Safe checks first, then the real causes a tech diagnoses